Opel Vectra A
since 1988-1995 of release
Repair and car operation
Vektr A. Opel
- 1. Maintenance instruction
Governing bodies and control devices
Control lamps of a combination of devices
Double information display
Heating and ventilation
Instructions on driving
Control lamp of electronic system of the engine
Exhaust system, exhaust gases
HARDWARE system (Traction Control)
Wheels and tires
Parameters of engines
Bases of safe operation of the car
+ Weekly checks and service in a way
Operational materials and liquids
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrosystems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions
Heating system and ventilation
System of mixing of Orel air
The stream of air depends on speed of movement and обдува. Therefore having blown include even at movement.
Openings for air always hold opened and close only for a while, for example, at penetration outside of a smoke, for this purpose both regulators put on, all nozzles обдува close.
The fan of a heater has 4 speeds.
Intensity of an air stream increases at turning on of the fan of a heater. For increase of comfort turn on the heater fan also during movement.
The lattice protecting hit of leaves in salon
Average nozzles of ventilation
Both nozzles open by means of a nakatny roller. In situation are closed.
The air flow increases at turning on of the fan of a heater.
The direction of a stream of air is regulated by turn of a rotating part and rotation of the lamely.
Lateral nozzles of ventilation
Through them cold or warm air - depending on the provision of a regulator moves.
The direction of a stream of air is regulated by rotation of the lamely.
Turn a temperature regulator to the left, turn on the heater fan.
For maximum обдува the top space, both regulators of heating establish on, all nozzles open.
For обдува the bottom space, the left regulator establish on.
Air stream to a back seat, average nozzles direct to each other and slightly up.
• Through nozzles to a windscreen and to lateral glasses.
• To forward and back bottom space.
• Through lateral nozzles обдува.
• In any combination.
Productivity of heating depends on temperature of cooling liquid and is established therefore only at the heated-up engine.
For fast warming up of salon turn a temperature regulator to the right and include a stage обдува 3.
The mood, health and comfort of passengers highly depend on the correct control of systems of ventilation and heating.
By installation on heating of the bottom space and opening on requirement of averages snuffled обдува it is possible to achieve temperature drop in salon by a principle "the head in cold, and feet in heat".
Heating of the bottom space
Warming channels are laid as well to back bottom space.
Moisture and hoarfrost removal from glasses
Heating of back glass, heating of an external mirror
The switch near a key обдува (a yellow control lamp of inclusion).
Press = it is included
Repeatedly press = it is switched off
Heating is disconnected automatically approximately in 15 minutes.
Electric heating of forward seats
Two switches are located under an ashtray.