Opel Vectra A

since 1988-1995 of release

Repair and car operation



Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
- 10. Engine electrosystems
   10.2. General information
   10.3. Ignition system
   10.4. Check of system of ignition
   10.5. Rules of care of the accumulator
   10.6. Accumulator check
   10.7. Battery charging
   10.8. Accumulator
   10.9. Charging system
   10.10. Generator
   10.11. Driving belt of the generator
   10.12. Removal and generator installation
   10.13. Generator brushes
   10.14. BOSCH generator
   10.15. Small-sized DELCO-REMY generator
   10.16. System of start of the engine
   10.17. Starter
   10.18. Removal and starter installation
   10.19. Ignition coil
   10.20. Cover and rotor of the distributor of ignition
   10.21. Distributor of ignition (SOHC model)
   10.22. Distributor of ignition (DOHC model)
   + 10.23. Repair of the distributor of ignition
   10.24. Check and adjustment of a corner of an advancing of ignition
   10.25. Fine tuning of the moment of ignition under a used grade of fuel
   10.26. Electronic modules
   10.27. Elements MSTS-i
   10.28. Sensor of speed/provision of a cranked shaft (model of 1,8 l)
   10.29. Motronic system elements
   10.30. Sensor of a detonation (DOHC model)
   10.31. DIS module
   10.32. Sensor of phases of a camshaft (HE C20 engine)
   10.33. System of prestarting heating
   10.34. Glow plugs
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions



10.33. System of prestarting heating

GENERAL INFORMATION

In each vortical chamber устанавли the glow plug is howled. Glow plugs are used at start of the cold engine. Tension giving to glow plugs copes a timer in a combination with diesel an electron the ny control device – injection system.

The control lamp in a combination of devices burns at work of candles of an incandescence. After lamp switching off the engine can be started. Tension to glow plugs moves within several seconds after inclusion of a control lamp. If attempt to start the engine after lamp switching off does not become, the timer disconnects tension from incandescence candles to avoid a discharge of the accumulator and an overheat of candles of an incandescence.

The fuel filter is also equipped with an element of heating which is established between the filter and a casing and copes system of prestarting heating. The element of heating joins, if the temperature of the fuel passing through the filter less 5°С and is switched off after when the temperature of fuel reaches 16°С.

Check

PERFORMANCE ORDER
1. Connect the voltmeter between feeding tire of candles of an incandescence and the earth. Include ignition and check that tension to candles moves in a sootvetstvo a yushchy interval of time.
2. At air temperature 20°С time intervals of giving of tension to glow plugs should make 3 seconds at which the control lamp burns. Time of burning of a control lamp increases at lower temperatures and decreases at temperature increase. If tension moves to glow plugs, the relay and electroconducting means are serviceable.
3. Using a tester, check integrity of candles of an incandescence, checking resistance between contact in the top part of a candle and the candle case. Сопротив leny glow plugs less than 1 Ohm and if the tester shows bigger resistance, the glow plug is faulty.