Opel Vectra A

since 1988-1995 of release

Repair and car operation



Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrosystems
- 11. Transmission
   11.2. General information
   11.3. Coupling cable
   11.4. Adjustment of a cable of coupling
   11.5. Coupling pedal
   + 11.6. Couplings (the engine and a transmission are established in the car)
   11.7. Coupling (the transmission is removed)
   11.8. Vyzhimna bearing
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions



11.2. General information

GENERAL INFORMATION

Coupling

Flywheel design

1–the flat flywheel established on early models;
2–the chasheobrazny flywheel established on later models


Coupling is intended for short-term separation of the engine and transmission at gear shifting or braking and their smooth connection at a car troganiye from a place, and also for protection of details of transmission from dynamic loadings.

Coupling consists of a disk of coupling, a leading part of coupling with a press disk and the mechanism of switching off of coupling.

The disk of coupling is established between a flywheel and a press disk of coupling and moves on shlitsa of primary shaft of a transmission.

To disconnect the engine from a transmission, it is necessary to take away vyzhimny a disk from a coupling disk. It is reached by use of a hummock drive. The fork of switching off of coupling moves vyzhimny the bearing which influences a spring of a vyzhimny disk and takes away press a disk from a coupling disk.

Such design of coupling allows to replace a disk of coupling, vyzhimny the bearing and a sealing ring of the directing plug without removal of the engine or a transmission from the car.

Since 1992 on models 1,8 and 2,0 of l started to establish a chasheobrazny flywheel (see fig. Flywheel design). Thus the torque is transferred more smoothly and transmission vibration decreases. However for replacement of a disk of coupling it is necessary to remove a transmission.