Opel Vectra A

since 1988-1995 of release

Repair and car operation



Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrosystems
- 11. Transmission
   11.2. General information
   11.3. Coupling cable
   11.4. Adjustment of a cable of coupling
   11.5. Coupling pedal
   + 11.6. Couplings (the engine and a transmission are established in the car)
   11.7. Coupling (the transmission is removed)
   11.8. Vyzhimna bearing
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions



11.5. Coupling pedal

Removal

Arrangement of a bracket of fixing of an axis of a pedal of coupling

Elements of a pedal the couplings located as if a pedal of coupling would be in the car
And – a place of fastening of a cable of coupling by a returnable spring

Elements of an axis of fastening of a pedal of coupling

PERFORMANCE ORDER
1. In a motor compartment measure length of a carving tip of a cable of the coupling, acting of the squeezing lever. This size is necessary for using for ensuring the correct installation of a cable of coupling.
2. Remove a bracket, fixing a carving tip of a cable of coupling to the squeezing lever, and remove from the lever a carving tip. For simplification of removal move the lever to the engine.
3. In salon of the car remove the bottom panel of furnish in deepening for feet of the driver.
4. On the right side of an axis of a pedal of coupling remove fixing bracket, then unscrew a nut of fastening of a pedal and remove a washer (see fig. Arrangement of a bracket of fixing of an axis of a pedal of coupling).
5. Take an axis of a pedal of coupling from an arm, then lower down a pedal and a returnable spring. Note an arrangement of washers and laying on an axis of a pedal of coupling for their repeated installation on the places.
6. Disconnect a coupling cable from a coupling pedal, release a returnable spring and take a pedal of coupling and a returnable spring from the car (see fig. Elements of a pedal the couplings located as if a pedal of coupling would be in the car, Elements of an axis of fastening of a pedal of coupling).

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal. Before installation grease an axis of a pedal of coupling with greasing on the basis of a molybdenum disulfide.
2. If necessary adjust a coupling cable.