Opel Vectra A

since 1988-1995 of release

Repair and car operation



Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrosystems
+ 11. Transmission
- 12. Mechanical transmission
   12.2. General information
   12.3. Adjustment of draft of the mechanism of a choice of transfers
   12.4. Knot of the lever of gear shifting
   12.5. Draft of the mechanism of a choice of transfers
   12.6. Gear shifting lever
   12.7. Protective cover of the lever of gear shifting
   12.8. Sealing rings of differential
   12.9. Sealing ring of an entrance shaft of a transmission
   12.10. Removal and transmission installation
   12.11. Transmission repair
   12.12. Speedometer drive
   12.13. Switch of lamps of a backing
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions



12.2. General information

GENERAL INFORMATION

The transmission is placed in a case from an aluminum alloy and attached to the left end face of the engine. It consists of a transmission, the main transfer and differential.

The torque from a cranked shaft of the engine is transferred through coupling to primary shaft of a transmission on which the coupling disk is established. From a secondary shaft the torque is transferred to differential and to power shafts.

In neutral situation primary shaft and gear wheels of a secondary shaft rotate freely and do not transfer a torque to differential.

The mechanism of gear shifting is put in action by the lever, located on a car floor by means of a switching rod. The mechanism of gear shifting moves the corresponding fork which moves the synchronizer and provides rigid connection of a gear wheel of a secondary shaft with secondary shaft.

Elements are located a heel of transfer under a cover in a transmission end face.

The reverse gear joins at the expense of gearing of an intermediate gear wheel with two pryamozuby gear wheels, is established ny on primary and secondary shaft of a transmission.

In a transmission kosozuby gear wheels that reduces level of noise are used and increases wear resistance.

On a transmission of F18 there is a special mechanism which allows to include a reverse gear silently.