Opel Vectra A

since 1988-1995 of release

Repair and car operation



Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrosystems
+ 11. Transmission
- 12. Mechanical transmission
   12.2. General information
   12.3. Adjustment of draft of the mechanism of a choice of transfers
   12.4. Knot of the lever of gear shifting
   12.5. Draft of the mechanism of a choice of transfers
   12.6. Gear shifting lever
   12.7. Protective cover of the lever of gear shifting
   12.8. Sealing rings of differential
   12.9. Sealing ring of an entrance shaft of a transmission
   12.10. Removal and transmission installation
   12.11. Transmission repair
   12.12. Speedometer drive
   12.13. Switch of lamps of a backing
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions



12.4. Knot of the lever of gear shifting

Removal

PERFORMANCE ORDER
1. In a motor compartment weaken tightening a bolt, a fixing rod of the mechanism of a choice of transfer to draft.
2. Remove the gear shifting lever.
3. Remove a forward part of the central console.
4. Unscrew four bolts, fixing knot of the lever of gear shifting to the car bottom.
5. Move knot of the lever of a choice of transfers together with a rod to a back part of the car and take a rod through a partition, thus the assistant should remove a clip not to damage rubber consolidation in a partition from the rod end.
6. If necessary replace rubber consolidation in a partition.

Installation

PERFORMANCE ORDER
1. For replacement of the plug of a rod of the mechanism of a choice of transfers move a rod from knot of the lever of gear shifting. Using a screw-driver edge as the lever, remove plug assembly from knot of the lever of gear shifting, then take the plug from a casing. Assembly make in sequence, return dismantling, thus grease with silicone greasing an internal surface of the plug.
2. Installation is made in sequence, return to removal but before tightening tightening a bolt of a rod of the mechanism of a choice of transfers, adjust draft of the mechanism of a choice of transfers.