Opel Vectra A

since 1988-1995 of release

Repair and car operation



Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrosystems
+ 11. Transmission
- 12. Mechanical transmission
   12.2. General information
   12.3. Adjustment of draft of the mechanism of a choice of transfers
   12.4. Knot of the lever of gear shifting
   12.5. Draft of the mechanism of a choice of transfers
   12.6. Gear shifting lever
   12.7. Protective cover of the lever of gear shifting
   12.8. Sealing rings of differential
   12.9. Sealing ring of an entrance shaft of a transmission
   12.10. Removal and transmission installation
   12.11. Transmission repair
   12.12. Speedometer drive
   12.13. Switch of lamps of a backing
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions



12.9. Sealing ring of an entrance shaft of a transmission

GENERAL INFORMATION

Prevention

At installation it is necessary to use a new sealing ring of the directing plug of the vyzhimny bearing.


Removal

PERFORMANCE ORDER
1. Remove vyzhimny the bearing and a fork of switching off of coupling.
2. Unscrew bolts and remove directing plugs of the vyzhimny bearing from a coupling case. Remove a sealant aching a ring located between the directing plug and a case of coupling.
3. Using a screw-driver edge as the lever, remove a sealing ring from the directing plug of the vyzhimny bearing.

Installation

PERFORMANCE ORDER
1. Using a tubular opravka of the corresponding diameter, establish a new sealing ring in directing plug.
2. Fill space between working edges of a new sealing ring lithium greasing, then establish directing plug with a new sealing ring, without using greasing.
3. Establish vyzhimny the bearing and a fork of switching off of coupling.