Opel Vectra A

since 1988-1995 of release

Repair and car operation



Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrosystems
+ 11. Transmission
+ 12. Mechanical transmission
- 13. Automatic transmission
   13.2. General information
   13.3. Replacement of transmission liquid
   13.4. Adjustment of the mechanism of compulsory inclusion of a low gear
   13.5. Mechanism of compulsory inclusion of a low gear
   13.6. Switch of blocking of a starter
   13.7. Adjustment of a cable of gear shifting
   13.8. Gear shifting cable
   13.9. Selector lever
   13.10. Central console
   13.11. Switches подрежима
   13.12. Electronic control device (ECU)
   13.13. Replacement of a lamp of illumination of the panel of the lever of the selector
   13.14. Hoses and tubes of a radiator of cooling of transmission liquid
   13.15. Replacement of sealing rings of differential
   13.16. Sensor of temperature of transmission liquid
   13.17. Sensors of speed of rotation of entrance and target shaft
   13.18. Removal and installation of an automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions



13.11. Switches подрежима

SWITCH PODREZHIMOV "ECONOMIC/SPORTS"

Removal

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. Remove the selector lever.
3. Insert a thin steel core into the bottom end of the lever and squeeze out the switch.
4. Mark and отпаяйте wires from the switch.

Installation

PERFORMANCE ORDER
1. According to earlier made marking solder wires to the new switch.
2. Establish the selector lever.

PODREZHIM'S SWITCH "WINTER"

Removal

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. Remove the panel of the lever of the selector from the central console for what release on two clamps from two parties of the panel, then move the panel aside and disconnect the electric socket from the switch.
3. Using a screw-driver edge as the lever, take the switch from the panel.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal.
.