Opel Vectra A

since 1988-1995 of release

Repair and car operation



Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrosystems
+ 11. Transmission
+ 12. Mechanical transmission
- 13. Automatic transmission
   13.2. General information
   13.3. Replacement of transmission liquid
   13.4. Adjustment of the mechanism of compulsory inclusion of a low gear
   13.5. Mechanism of compulsory inclusion of a low gear
   13.6. Switch of blocking of a starter
   13.7. Adjustment of a cable of gear shifting
   13.8. Gear shifting cable
   13.9. Selector lever
   13.10. Central console
   13.11. Switches подрежима
   13.12. Electronic control device (ECU)
   13.13. Replacement of a lamp of illumination of the panel of the lever of the selector
   13.14. Hoses and tubes of a radiator of cooling of transmission liquid
   13.15. Replacement of sealing rings of differential
   13.16. Sensor of temperature of transmission liquid
   13.17. Sensors of speed of rotation of entrance and target shaft
   13.18. Removal and installation of an automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions



13.15. Replacement of sealing rings of differential

Removal

PERFORMANCE ORDER
1. It is possible to replace sealing rings of bearings of differential on a transmission established in the car.
2. At existence remove a cap from a forward wheel, then weaken bolts of fastening of a wheel. Tighten the hand brake, then lift a forward part of the car and fix on supports. Unscrew bolts and remove a forward wheel.
3. Take шплинт, then unscrew the koronchaty nut, fixing the spherical hinge connecting the bottom lever from a resistant forward suspension bracket.
4. Using a stripper of spherical hinges, squeeze out a pin of the spherical hinge.
5. Merge transmission liquid.
6. Having pulled a nave of a forward wheel outside, take from differential the internal end of a power shaft. Using a soft wire, adhere the internal end of a power shaft to a body.
7. Using a screw-driver edge as the lever, take a sealing ring from differential.

Installation

PERFORMANCE ORDER
1. Grease working edges of a new sealing ring with transmission oil, then, using a tubular opravka of the corresponding diameter, establish a new sealing ring in a differential nest.
2. Establish in a flute on the internal end of a power shaft a new lock ring and insert a power shaft into differential.
3. Establish the spherical hinge connecting the bottom lever of a forward suspension bracket from a resistant suspension bracket and screw a koronchaty nut on a pin of the hinge and tighten it the demanded moment. Insert new шплинт, fixing a nut from unscrewing.
4. Establish a wheel, then lower the car on the earth and finally tighten bolts of fastening of a wheel. At existence establish a wheel cap.
5. Fill in oil in a transmission.