Opel Vectra A

since 1988-1995 of release

Repair and car operation



Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrosystems
+ 11. Transmission
+ 12. Mechanical transmission
- 13. Automatic transmission
   13.2. General information
   13.3. Replacement of transmission liquid
   13.4. Adjustment of the mechanism of compulsory inclusion of a low gear
   13.5. Mechanism of compulsory inclusion of a low gear
   13.6. Switch of blocking of a starter
   13.7. Adjustment of a cable of gear shifting
   13.8. Gear shifting cable
   13.9. Selector lever
   13.10. Central console
   13.11. Switches подрежима
   13.12. Electronic control device (ECU)
   13.13. Replacement of a lamp of illumination of the panel of the lever of the selector
   13.14. Hoses and tubes of a radiator of cooling of transmission liquid
   13.15. Replacement of sealing rings of differential
   13.16. Sensor of temperature of transmission liquid
   13.17. Sensors of speed of rotation of entrance and target shaft
   13.18. Removal and installation of an automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions



13.7. Adjustment of a cable of gear shifting

GENERAL INFORMATION

Installation of the lever of a choice of transfers on a transmission in situation P (1) and N (2)

Adjustment of a cable of gear shifting

For adjustment of a cable of gear shifting release clamps (shooters) and move the selector panel aside.

1–an installation site of a cap key for weakening of a bolt of fastening of a cable.


PERFORMANCE ORDER
1. Moving the selector lever to all provisions, check that thus the lever of a choice of transfers on a transmission also is established in the relevant situation. Position P of the lever of a choice of transfers is located in a forward part, and situation N has a label, thus all other provisions are noted (see fig. Installation of the lever of a choice of transfers on a transmission in situation P (1) and N (2)). Check that when moving the lever to the provision P of a wheel are blocked.
2. For carrying out adjustment establish the lever of a choice of transfers to R.Osvobodite's position fastening of the panel of the lever of the selector for what press on two clamps from two parties of the panel and move the panel aside (see fig. Adjustment of a cable of gear shifting).
3. Through the opened aperture a cap key weaken a bolt of fastening of a cable.
4. In a motor compartment move a control lever a transmission forward and to the right to its emphasis to the limiter.
5. Holding the lever in this situation, tighten a bolt of fastening of a cable the demanded moment.
6. Establish the panel of the lever of the selector and check operation of the mechanism of a choice of transfers.