Opel Vectra A

since 1988-1995 of release

Repair and car operation



Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrosystems
+ 11. Transmission
+ 12. Mechanical transmission
- 13. Automatic transmission
   13.2. General information
   13.3. Replacement of transmission liquid
   13.4. Adjustment of the mechanism of compulsory inclusion of a low gear
   13.5. Mechanism of compulsory inclusion of a low gear
   13.6. Switch of blocking of a starter
   13.7. Adjustment of a cable of gear shifting
   13.8. Gear shifting cable
   13.9. Selector lever
   13.10. Central console
   13.11. Switches подрежима
   13.12. Electronic control device (ECU)
   13.13. Replacement of a lamp of illumination of the panel of the lever of the selector
   13.14. Hoses and tubes of a radiator of cooling of transmission liquid
   13.15. Replacement of sealing rings of differential
   13.16. Sensor of temperature of transmission liquid
   13.17. Sensors of speed of rotation of entrance and target shaft
   13.18. Removal and installation of an automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions



13.9. Selector lever

Removal

Fastening of a cable of gear shifting to the lever
1–bolt of fastening of a cable;
2–lock-nut;
3–a nut of fastening of the lever to an axis

PERFORMANCE ORDER
1. Tighten the hand brake and establish the selector lever in situation P.
2. Remove a weight wire from the accumulator.
3. In salon of the car release from the central console the selector panel for what from two parties of the panel wring out two clamps and lift the panel. Remove an ashtray. Move a back part of the central console and remove the panel of the lever of the selector. Check that the hand brake will tighten, and move the selector lever to situation 2.
4. Weaken a bolt of fastening of a cable, then unscrew a lock-nut and take a cable from the lever. Disconnect electric sockets from switches подрежимов and remove the holder of a lamp of illumination of modes of the chosen transfer.
5. Unscrew a nut, fixing the selector lever to an axis and, turning, take the lever (see drawing).

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal.
2. Check and, if necessary, adjust a gear shifting cable.