Opel Vectra A

since 1988-1995 of release

Repair and car operation



Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrosystems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
- 14. Power shafts
   14.2. General information
   + 14.3. Power shaft
   14.4. Intermediate shaft
   14.5. Replacement of hinges of a power shaft
   14.6. Replacement of covers of hinges of equal angular speeds
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions



14.6. Replacement of covers of hinges of equal angular speeds

GENERAL INFORMATION

Back differential of the all-wheel drive car

Driveshaft of the all-wheel drive car

Back power shaft of all-wheel drive cars
1–nave;
2–lock ring;
3–bearing;
4–diagonal lever;
5–flange;
6–nut;
7–a flange with a gear rotor;
8–external CV JOINT;
9–power shaft;
10-internal CV JOINT

PERFORMANCE ORDER
1. Remove a power shaft. Remove from a power shaft the hinge of equal angular speeds. If replacement of two protective covers is necessary, remove from a power shaft only one hinge of equal angular speeds.
2. Remove collars of fastening of a protective cover and shift a protective cover from a power shaft.
3. Clean old greasing from the hinge of equal angular speeds and fill the hinge with new greasing.
4. Establish a new protective cover on a power shaft so that the flange of a protective cover was established in a flute of a power shaft.
5. Establish the hinge of equal angular speeds with a new lock ring on a power shaft. Thus the lock ring should be fixed accurately in a flute of a power shaft.
6. Establish a protective cover on the hinge of equal angular speeds, then let the air out from under a protective cover.
7. Fix a protective cover new collars.
8. Establish a power shaft in the car.