Opel Vectra A

since 1988-1995 of release

Repair and car operation



Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrosystems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
- 15. Brake system
   15.2. General information
   15.3. Anti-blocking system of brakes (ABS)
   15.4. Pumping of hydraulic brake system
   + 15.5. Replacement of forward brake shoes
   15.6. Replacement of back brake shoes on disk brakes
   + 15.7. Replacement of back brake shoes on drum-type brakes
   15.8. Replacement of brake shoes of the hand brake on back disk brakes
   15.9. Support of a forward brake
   15.10. Support of a back disk brake
   15.11. Brake disk
   15.12. Forward brake disk
   15.13. A back brake disk on models with SOHC engines
   15.14. A back brake disk on models with DOHC engines
   15.15. Brake drum
   15.16. Back working brake cylinder
   15.17. Brake board of a back brake
   15.18. Protective casing of a forward brake disk
   15.19. Main brake cylinder
   15.20. Repair of the main brake cylinder (model without ABS)
   15.21. Vacuum amplifier of brakes
   15.22. Hydraulic ABS modulator
   15.23. The ABS sensors established on wheels
   15.24. ABS control unit
   15.25. ABS relay (only ABS-2E system)
   15.26. Valves of adjustment of pressure
   15.27. Brake pipelines and hoses
   15.28. Adjustment of the hand brake
   + 15.29. Cable of the hand brake
   15.30. Lever of the hand brake
   15.31. Brake pedal
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions



15.27. Brake pipelines and hoses

GENERAL INFORMATION

Brake tubes are applied to transfer of brake liquid from the main brake cylinder to wheel brake cylinders. Connections of tubes with brake cylinders and the distributor ny devices are made by konusny couplings. The ends of tubes are pressed out and have a cone-shaped form for the corresponding size of konusny carving openings in brake cylinders or switching centers.

Before obzhatiy the ends of tubes the lock nut which after a vvinchivaniye of a cone-shaped surface in the konusny basis of a carving opening presses is put on them and pressurizes a tube.

Brake hoses carry out mobile communications between mobile and motionless parts of the car. For reduction of losses of brake liquid at removal of working brake cylinders clips for a perezhatiya of brake hoses are used.

At installation of a new brake tube or a brake hose be convinced that they are densely fixed in arms and are at sufficient distance from moving or heating-up details.

Upon termination of installation check level of brake liquid in the main brake cylinder and add it if necessary. Remove air from brake system and carefully check work of brakes before beginning car operation.