Opel Vectra A

since 1988-1995 of release

Repair and car operation



Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrosystems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
- 18. Electric equipment
   18.2. General information
   18.3. Electric chains
   18.4. Detection of a faulty chain
   18.5. Safety locks and relay
   18.6. Ignition lock
   18.7. Switch of lighting and indexes of turns
   18.8. Switch стеклоомывателя / screen wiper
   18.9. Switches on the dashboard
   18.10. Switch of adjustment of provision of an external mirror
   18.11. Switch of an electric drive of the hatch
   18.12. The switch of illumination of the salon, established in a door rack
   18.13. Switch of illumination of a luggage compartment
   18.14. Stoplight switch.
   18.15. Switch of a control lamp of the hand brake
   18.16. Sensor of pressure of oil
   18.17. Lighter illumination
   18.18. Hours
   18.19. A forward seat with heating
   18.20. Combination of devices
   18.21. Elements of a combination of devices
   18.22. Elements of the board computer
   18.23. Monitoring system and management elements
   18.24. Sound signal
   18.25. Lamp of illumination of salon
   18.26. Replacement of bulbs of internal lighting
   18.27. Headlight
   18.28. Engine of the proof-reader of light of headlights
   18.29. Adjustment of light of headlights
   18.30. System of reduction of intensity of light of headlights
   18.31. Forward index of turns
   18.32. Lateral repeater of turns
   18.33. Forward fog light
   18.34. Back lamps
   18.35. Lamp of illumination of registration plate
   + 18.36. Replacement of bulbs of external lighting
   18.37. Replacement of brushes of a screen wiper
   18.38. Screen wiper levers
   18.39. Washer jets
   18.40. Engine and drafts of a screen wiper
   18.41. Engine of a screen wiper of a back door
   18.42. Engine of a screen wiper of a headlight
   18.43. Tank of a stekloomyvatel
   18.44. Pump of a stekloomyvatel
   18.45. Unidirectional valve of a washer of headlights
   18.46. Elements of window regulators with an electric drive
   18.47. Programming of a control system by window regulators
   18.48. Elements of the central blocking of doors
   18.49. Aerial
   18.50. An aerial mast with an electric drive
   18.51. Loudspeakers
   18.52. Radio tape recorder
   18.53. Electric motor of a drive of the hatch
   18.54. Cable of a drive of a speedometer
   18.55. Anticreeping alarm system
   18.56. Elements of the anticreeping alarm system
   18.57. Safety cushion
   18.58. A safety cushion from the driver
   18.59. A steering wheel with a safety cushion
   18.60. Contact block of a safety cushion
   18.61. A safety cushion from the passenger
   18.62. A safety cushion arm from the passenger
   18.63. Control unit safety cushions
   + 18.64. Electric circuits
+ 19. Check of malfunctions



18.46. Elements of window regulators with an electric drive

GENERAL INFORMATION

Prevention

After removal and installation of any element of window regulators with an electric drive it is necessary to program system of window regulators.


Remove a weight wire from the accumulator.

THE SWITCHES ESTABLISHED ON THE DOOR

Removal

PERFORMANCE ORDER
1. Using an edge of a thin screw-driver as the lever, remove a decorative slip from the internal handle of opening of a door.
2. Using an edge of a thin screw-driver as the lever, take the switch from a nest and disconnect from it the electric socket.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal.

THE SWITCHES ESTABLISHED ON THE CENTRAL CONSOLE

Removal

PERFORMANCE ORDER
1. Switches act in film as uniform knot. If one of switches is faulty, it is necessary to replace the block of switches.
2. Remove a back part of the central console.
3. Release clamps and take the block of switches from the top part of the central console.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal.

LEKTRODVIGATELI OF THE DRIVE OF WINDOW REGULATORS

Arrangement of nuts of fastening of the electric motor of a window regulator of a forward door and screw of fastening of the block of impulses

PERFORMANCE ORDER
1. Remove a window regulator from a door.
2. For removal of the electric motor from a window regulator of a forward door unscrew three nuts, the fixing electric motor and the screw which the block of impulses to a window regulator fixes. Remove the electric motor with the block of impulses. Keep in mind that if the electric motor or the block of impulses are faulty, their replacement is necessary for making in collecting (see drawing).
3. The electric motor of the window regulator established in a back door, is an integral part of a window regulator.