Opel Vectra A

since 1988-1995 of release

Repair and car operation



Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
- 3. Repair of DOHC engines
   3.2. General information
   3.3. Removal and engine installation
   3.4. Replacement of support of the power unit
   + 3.5. Gear belt, pulleys, pulley of the mechanism of a tension and intermediate pulley
   3.6. A gear belt with the automatic mechanism of a tension
   3.7. Forward sealing ring of a camshaft
   3.8. Camshafts
   3.9. Installation of a head of the block of cylinders on the engine established in the car
   3.10. Installation of a head of the block of cylinders on the engine which has been removed from the car
   3.11. Repair of a head of the block of cylinders
   3.12. Hydraulic pushers of valves
   3.13. Replacement of a forward sealing ring of a cranked shaft
   3.14. Oil pallet
   3.15. Oil pump
   3.16. Oil radiator
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrosystems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions



3.15. Oil pump

GENERAL INFORMATION

Places of connection of tubes of an oil radiator to the oil pump

Arrangement of bolts of fastening of the oil pump (arrow) and arrangement of an intermediate ring of a cranked shaft (And)

Removal

Removal of the oil pump is made in the same way, as well as on the SOHC engine (see subsection 2.28).

PERFORMANCE ORDER
1. If removal of the oil pump is made from the engine established in the car, disconnect pipelines of an oil radiator from the oil pump and move them aside.
2. Remove from a cranked shaft промежуточ aching a ring (see fig. Arrangement of bolts of fastening of the oil pump and arrangement of an intermediate ring of a cranked shaft).

Installation

Installation of the oil pump is made in the same way, as well as on SOHC engines (see subsection 2.28).

PERFORMANCE ORDER
1. Apply a thin film hermetic on an interfaced surface of the oil pump with an intermediate ring, then establish an intermediate ring on a cranked shaft to a contact of its oil pump.
2. Establish a new gear belt.
3. Connect the pipes going from an oil radiator to the oil pump.