Opel Vectra A

since 1988-1995 of release

Repair and car operation



Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
- 3. Repair of DOHC engines
   3.2. General information
   3.3. Removal and engine installation
   3.4. Replacement of support of the power unit
   + 3.5. Gear belt, pulleys, pulley of the mechanism of a tension and intermediate pulley
   3.6. A gear belt with the automatic mechanism of a tension
   3.7. Forward sealing ring of a camshaft
   3.8. Camshafts
   3.9. Installation of a head of the block of cylinders on the engine established in the car
   3.10. Installation of a head of the block of cylinders on the engine which has been removed from the car
   3.11. Repair of a head of the block of cylinders
   3.12. Hydraulic pushers of valves
   3.13. Replacement of a forward sealing ring of a cranked shaft
   3.14. Oil pallet
   3.15. Oil pump
   3.16. Oil radiator
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrosystems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions



3.7. Forward sealing ring of a camshaft

GENERAL INFORMATION

Prevention

At installation of a sealing ring of a camshaft it is necessary to use a new gear belt.


Removal

It is possible to replace a forward sealing ring of a camshaft on the engine established in the car.

PERFORMANCE ORDER
1. Remove a gear belt and the corresponding pulley of a camshaft.
2. Drill in a sealing ring two small openings located in the opposite ends of consolidation. Screw in two self-cutting screws in the drilled openings of a sealing ring and, using flat-nose pliers, extend for heads of screws a sealing ring.
3. Clear a nest of a sealing ring.

Installation

Installation of a new forward sealing ring распреде litelny shaft

PERFORMANCE ORDER
1. Turn a camshaft in such situation that the adjusting pin was in the top situation, then grease working edges of a new sealing ring with engine oil and establish a sealing ring. For installation of a sealing ring use a tubular opravka of the corresponding diameter and a big washer and, screwing in a bolt of fastening of a pulley distribute a telny shaft press a sealing ring into a nest (see drawing).
2. If necessary similarly replace a sealing ring of the second camshaft.
3. Establish pulleys of camshafts and a gear belt. Adjust a tension of a gear belt.