Opel Vectra A

since 1988-1995 of release

Repair and car operation



Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
- 4. Repair of the diesel engine
   4.2. General information
   4.3. The repair which is not demanding removal of the engine
   4.4. Compression check
   4.5. Top dead point (VMT) of the piston of the first cylinder
   4.6. Cover of a head of the block of cylinders
   4.7. Pulley of a cranked shaft
   4.8. Casings of a gear belt
   4.9. Replacement of a gear belt
   4.10. Check and installation of phases of a gazoraspredeleniye
   + 4.11. Mechanism of a tension of a gear belt and pulleys
   4.12. Replacement of a sealing ring of a camshaft
   4.13. Check and adjustment of gaps of valves
   4.14. Camshaft and pushers
   4.15. Head of the block of cylinders
   4.16. Oil pallet
   4.17. Oil pump
   4.18. Replacement of a sealing ring of the oil pump
   4.19. Oil radiator
   + 4.20. Pistons with rods
   4.21. Flywheel
   4.22. Replacement of sealing rings of a cranked shaft
   4.23. Replacement of support of the power unit
   4.24. Recommendations about engine removal
   4.25. Removal and engine installation
   4.26. Engine repair
   4.27. Engine start after major maintenance
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrosystems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions



4.12. Replacement of a sealing ring of a camshaft

GENERAL INFORMATION

Arrangement of bolts of fastening of a back casing of a gear belt to a head of the block of cylinders

PERFORMANCE ORDER
1. Remove a camshaft pulley.
2. Unscrew bolts of fastening of a back casing of a gear belt of a head of the block of cylinders and move a casing of a gear belt as it is possible further from a head. For the best access to oil condense to a telny ring of a camshaft completely remove a back casing of a gear belt.
3. Drill two small openings in end faces of a sealing ring. Screw in two self-cutting screws and flat-nose pliers for heads of screws extend a sealing ring from a nest.
4. Clear a nest of a sealing ring and a condensed surface of a camshaft.
5. Grease a new sealing ring with pure engine oil and, using a tubular opravka, establish it into place.
6. Screw in bolts of fastening of the top part of a back casing of a gear belt to a head of the block of cylinders.
7. Establish a camshaft pulley.