Opel Vectra A

since 1988-1995 of release

Repair and car operation



Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
- 4. Repair of the diesel engine
   4.2. General information
   4.3. The repair which is not demanding removal of the engine
   4.4. Compression check
   4.5. Top dead point (VMT) of the piston of the first cylinder
   4.6. Cover of a head of the block of cylinders
   4.7. Pulley of a cranked shaft
   4.8. Casings of a gear belt
   4.9. Replacement of a gear belt
   4.10. Check and installation of phases of a gazoraspredeleniye
   + 4.11. Mechanism of a tension of a gear belt and pulleys
   4.12. Replacement of a sealing ring of a camshaft
   4.13. Check and adjustment of gaps of valves
   4.14. Camshaft and pushers
   4.15. Head of the block of cylinders
   4.16. Oil pallet
   4.17. Oil pump
   4.18. Replacement of a sealing ring of the oil pump
   4.19. Oil radiator
   + 4.20. Pistons with rods
   4.21. Flywheel
   4.22. Replacement of sealing rings of a cranked shaft
   4.23. Replacement of support of the power unit
   4.24. Recommendations about engine removal
   4.25. Removal and engine installation
   4.26. Engine repair
   4.27. Engine start after major maintenance
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrosystems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions



4.21. Flywheel

GENERAL INFORMATION

Prevention

At installation of a flywheel it is necessary to use new bolts.


Removal

Fixing of a gear wreath of a flywheel from a provorachivaniye


Removal of a fixing plate from a flywheel

PERFORMANCE ORDER
1. Remove a transmission and coupling.
2. Fix a flywheel from a provorachivaniye, having established a clamp on a gear wreath of a flywheel (see fig. Fixing of a gear wreath of a flywheel from a provorachivaniye). Put on a cranked shaft and a flywheel a combination label.
3. Unscrew bolts and remove a flywheel (see fig. Removal of a fixing plate from a flywheel).

Check

PERFORMANCE ORDER

1. Check a flywheel on wear from coupling and a condition of teeths of a gear wreath of a flywheel.

Installation

Tightening of bolts of fastening of a flywheel

PERFORMANCE ORDER
1. Clear interfaced surfaces of a flywheel and a cranked shaft.
2. Put the means interfering unscrewing of bolts on a carving of bolts of fastening of a cranked shaft.
3. Establish a flywheel according to earlier put label and fix bolts, having tightened them the demanded moment.
4. Remove a clamp of blocking of a flywheel and establish a transmission.