Opel Vectra A

since 1988-1995 of release

Repair and car operation



Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
- 4. Repair of the diesel engine
   4.2. General information
   4.3. The repair which is not demanding removal of the engine
   4.4. Compression check
   4.5. Top dead point (VMT) of the piston of the first cylinder
   4.6. Cover of a head of the block of cylinders
   4.7. Pulley of a cranked shaft
   4.8. Casings of a gear belt
   4.9. Replacement of a gear belt
   4.10. Check and installation of phases of a gazoraspredeleniye
   + 4.11. Mechanism of a tension of a gear belt and pulleys
   4.12. Replacement of a sealing ring of a camshaft
   4.13. Check and adjustment of gaps of valves
   4.14. Camshaft and pushers
   4.15. Head of the block of cylinders
   4.16. Oil pallet
   4.17. Oil pump
   4.18. Replacement of a sealing ring of the oil pump
   4.19. Oil radiator
   + 4.20. Pistons with rods
   4.21. Flywheel
   4.22. Replacement of sealing rings of a cranked shaft
   4.23. Replacement of support of the power unit
   4.24. Recommendations about engine removal
   4.25. Removal and engine installation
   4.26. Engine repair
   4.27. Engine start after major maintenance
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrosystems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions



4.22. Replacement of sealing rings of a cranked shaft

Right sealing ring

PERFORMANCE ORDER
1. Remove a pulley of a cranked shaft.
2. Drill in a sealing ring two small openings, located in the opposite ends of consolidation. Screw in two самонарезаю shchy the screw in the drilled openings of a sealing ring and, using flat-nose pliers, extend for heads of screws a sealing ring.
3. Clear a nest of a sealing ring.
4. Grease with pure engine oil working edges of a new sealing ring and establish it on a cranked shaft. Working edges of a new sealing ring should be directed inside.
5. Remove all traces of engine oil and establish a pulley on a cranked shaft.

Left sealing ring

PERFORMANCE ORDER
1. Remove a flywheel.
2. Drill in a sealing ring two small openings, located in the opposite ends of consolidation. Screw in two самонарезаю shchy the screw in the drilled openings of a sealing ring and, using flat-nose pliers, extend for heads of screws a sealing ring.
3. Clear a nest of a sealing ring.
4. Grease with pure engine oil working edges of a new sealing ring and establish it on a cranked shaft. Working edges of a new sealing ring should be directed inside.
5. Establish a flywheel.