Opel Vectra A

since 1988-1995 of release

Repair and car operation



Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
- 4. Repair of the diesel engine
   4.2. General information
   4.3. The repair which is not demanding removal of the engine
   4.4. Compression check
   4.5. Top dead point (VMT) of the piston of the first cylinder
   4.6. Cover of a head of the block of cylinders
   4.7. Pulley of a cranked shaft
   4.8. Casings of a gear belt
   4.9. Replacement of a gear belt
   4.10. Check and installation of phases of a gazoraspredeleniye
   + 4.11. Mechanism of a tension of a gear belt and pulleys
   4.12. Replacement of a sealing ring of a camshaft
   4.13. Check and adjustment of gaps of valves
   4.14. Camshaft and pushers
   4.15. Head of the block of cylinders
   4.16. Oil pallet
   4.17. Oil pump
   4.18. Replacement of a sealing ring of the oil pump
   4.19. Oil radiator
   + 4.20. Pistons with rods
   4.21. Flywheel
   4.22. Replacement of sealing rings of a cranked shaft
   4.23. Replacement of support of the power unit
   4.24. Recommendations about engine removal
   4.25. Removal and engine installation
   4.26. Engine repair
   4.27. Engine start after major maintenance
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrosystems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions



4.26. Engine repair

GENERAL INFORMATION

The main operations on repair of the engine are similar to operations on SOHC engine repair (see subsection 2).

It is most convenient to perform works on the engine if it is established on a special bed.

Before engine repair it is necessary to remove from it:

– inlet and final collectors;
– arm of the pump of strengthening of a steering and generator;
– water pump;
– elements of fuel system;
– plait of wires and all electric switches, and sensors;
– oil filter;
– flywheel.

If it is necessary to make only repair of the block of cylinders, a cranked shaft, pistons and rods, it is necessary to remove a head of the block of cylinders, the oil pallet, the oil pump and a gear belt of a drive.

In need of carrying out complete major maintenance it is necessary to remove from the engine:

– inlet and final collectors;
– gear belt of a drive, pulleys and tension mechanism;
– head of the block of cylinders;
– flywheel;
– oil pallet;
– oil pump;
– pistons with rods;
– cranked shaft.