Opel Vectra A

since 1988-1995 of release

Repair and car operation



Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
- 4. Repair of the diesel engine
   4.2. General information
   4.3. The repair which is not demanding removal of the engine
   4.4. Compression check
   4.5. Top dead point (VMT) of the piston of the first cylinder
   4.6. Cover of a head of the block of cylinders
   4.7. Pulley of a cranked shaft
   4.8. Casings of a gear belt
   4.9. Replacement of a gear belt
   4.10. Check and installation of phases of a gazoraspredeleniye
   + 4.11. Mechanism of a tension of a gear belt and pulleys
   4.12. Replacement of a sealing ring of a camshaft
   4.13. Check and adjustment of gaps of valves
   4.14. Camshaft and pushers
   4.15. Head of the block of cylinders
   4.16. Oil pallet
   4.17. Oil pump
   4.18. Replacement of a sealing ring of the oil pump
   4.19. Oil radiator
   + 4.20. Pistons with rods
   4.21. Flywheel
   4.22. Replacement of sealing rings of a cranked shaft
   4.23. Replacement of support of the power unit
   4.24. Recommendations about engine removal
   4.25. Removal and engine installation
   4.26. Engine repair
   4.27. Engine start after major maintenance
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrosystems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions



4.8. Casings of a gear belt

Removal

TOP CASING

PERFORMANCE ORDER
1. Lift a forward part of the car and fix on supports. Remove the right forward wheel.
2. Remove a casing of the air filter.
3. Remove auxiliary driving belts.
4. Establish under the engine a jack and through wooden whetstone raise the engine until all top of the engine will not be perceived by a jack. Unscrew nuts and remove the right suspension bracket of the power unit.
5. Unscrew bolts and remove the top casing of a gear belt together with rubber consolidation.

BOTTOM CASING

PERFORMANCE ORDER
1. Remove the top casing of a gear belt.
2. Remove a pulley of a cranked shaft.
3. Unscrew bolts and remove the bottom casing of a gear belt together with rubber consolidation.

INTERNAL CASING

PERFORMANCE ORDER
1. Remove a gear belt.
2. Remove a camshaft pulley, a pulley of the fuel pump of a high pressure, a single pulley and the tension mechanism.
3. Unscrew bolts and remove an internal casing of a gear belt.

Installation

Installation of rubber laying in a casing of a gear belt

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal. Thus check correctness of an arrangement of rubber laying (see drawing).