Opel Vectra A

since 1988-1995 of release

Repair and car operation



Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
- 6. Fuel system
   6.2. General information
   6.3. Air filter
   6.4. The block of adjustment of temperature of air arriving in the engine
   6.5. Check of the fuel pump
   6.6. Removal and installation of the fuel pump
   6.7. Fuel tank
   6.8. Fuel level sensor
   6.9. Separator паров fuels (l model 1,6 and 1,8)
   6.10. Accelerator pedal
   6.11. Accelerator cable
   6.12. Carburetor
   6.13. Removal and carburetor installation
   6.14. Adjustment of turns of idling and the contents WITH
   6.15. Needle and float
   6.16. Vacuum diaphragm of a butterfly valve of the secondary chamber
   6.17. Diaphragm of an ekonomayzer
   6.18. Accelerating pump
   6.19. Knot of an air automatic zaslonka
   + 6.20. Vacuum blocks of moving of an air automatic zaslonka
   6.21. Carburetor filter
   6.22. Adjustment of the shock-absorber of a butterfly valve
   6.23. Sensor of provision of a butterfly valve (an automatic transmission)
   6.24. Check of the valve of increase in turns of idling
   6.25. The electromagnetic valve of idling on models of 1,8 l
   6.26. Inlet collector
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrosystems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions



6.21. Carburetor filter

Removal

PERFORMANCE ORDER
1. The fuel filter in the form of a tubule is established in the top cover of the carburetor.
2. Replacement of the fuel filter make through 30 000 km of run or each 24 months.
3. Depending on model remove either the air filter, or the air chamber from the top part of the carburetor. Remove from the union of the top cover of the carburetor a fuel hose and close it a suitable stopper.
4. Take from an union opening the fuel filter for what use an edge of a thin screw-driver or screw in in the filter the screw with the M3 carving on depth of 5 mm.
5. If the fuel filter is strongly polluted or has damages, replace it. If the fuel filter in a normal state, blow it the compressed air and wash out in pure solvent.

Installation

Installation of the fuel filter in a carburetor cover

PERFORMANCE ORDER
1. At installation of the fuel filter press it into an union opening before its accurate fixing (see drawing). Further installation is made in sequence, return to removal.