Opel Vectra A

since 1988-1995 of release

Repair and car operation



Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
- 6. Fuel system
   6.2. General information
   6.3. Air filter
   6.4. The block of adjustment of temperature of air arriving in the engine
   6.5. Check of the fuel pump
   6.6. Removal and installation of the fuel pump
   6.7. Fuel tank
   6.8. Fuel level sensor
   6.9. Separator паров fuels (l model 1,6 and 1,8)
   6.10. Accelerator pedal
   6.11. Accelerator cable
   6.12. Carburetor
   6.13. Removal and carburetor installation
   6.14. Adjustment of turns of idling and the contents WITH
   6.15. Needle and float
   6.16. Vacuum diaphragm of a butterfly valve of the secondary chamber
   6.17. Diaphragm of an ekonomayzer
   6.18. Accelerating pump
   6.19. Knot of an air automatic zaslonka
   + 6.20. Vacuum blocks of moving of an air automatic zaslonka
   6.21. Carburetor filter
   6.22. Adjustment of the shock-absorber of a butterfly valve
   6.23. Sensor of provision of a butterfly valve (an automatic transmission)
   6.24. Check of the valve of increase in turns of idling
   6.25. The electromagnetic valve of idling on models of 1,8 l
   6.26. Inlet collector
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrosystems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions



6.9. Separator паров fuels (l model 1,6 and 1,8)

GENERAL INFORMATION

The separator паров fuels is fixed on an arm sideways the carburetor.

Removal

PERFORMANCE ORDER
1. Mark three fuel hoses, then disconnect them from a separator паров fuels. Close the ends of hoses suitable jams.
2. Unscrew two screws and remove a separator паров fuels from an arm.
3. Check a case condition сепарато ра and in the presence of cracks or traces of leaks, replace it.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal. Podsoyedi of a thread hoses to a separator паров fuels according to earlier put marking.
2. Start the engine and check tightness of connection of hoses to a fuel separator. In the presence of leakage of fuel immediately switch off the engine and eliminate the leak reason.