Opel Vectra A

since 1988-1995 of release

Repair and car operation



Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
- 8. Exhaust system and system of fall of toxicity of exhaust gases
   8.2. System of fall of toxicity of exhaust gases
   8.3. System of repeated burning of exhaust gases (EGR)
   8.4. The EGR valve (models with Multec system)
   8.5. EGR valve (Simtec system)
   8.6. EGR module (X16 SZ models)
   8.7. Knot of the air pump (Simtec system)
   8.8. Valve of an otsechka of system of reduction of toxicity
   8.9. The switching-off valve of system of reduction of toxicity
   8.10. Tube and unidirectional valve of system of reduction of toxicity
   8.11. Catalyst
   8.12. The canister with coal
   8.13. The oxygen sensor (models with the catalyst)
   8.14. Final collector
   + 8.15. Exhaust system
+ 9. Fuel systems of the diesel engine
+ 10. Engine electrosystems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions



8.5. EGR valve (Simtec system)

GENERAL INFORMATION

Prevention

At installation of the valve it is necessary to use new laying.


Removal

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. Remove a plait of wires and a vacuum hose.
3. Note a valve arrangement for the correct repeated installation it into place.
4. Unscrew three bolts and remove the valve from a flange of cooling of the dual coil of ignition.

Installation

Simtec system EGR valve

1–valve;

2–laying


PERFORMANCE ORDER
1. Clear interfaced surfaces of a flange and the valve.
2. Establish the valve according to the labels put before removal of the valve (see drawing).