Opel Vectra A

since 1988-1995 of release

Repair and car operation



Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
- 9. Fuel systems of the diesel engine
   9.2. General information
   9.3. Case of the air filter
   9.4. Accelerator pedal
   9.5. Fuel level sensor
   9.6. Fuel tank
   9.7. Heater of the fuel filter
   9.8. Water plums from the fuel filter
   9.9. Filling and pumping of fuel system
   9.10. Check and adjustment of the maximum turns
   9.11. Check and adjustment of turns of idling
   9.12. Electromagnetic valve of a stop of the engine
   9.13. Fuel pump of a high pressure
   9.14. Check and adjustment of the moment of injection of fuel
   9.15. Fuel nozzles
   9.16. Turbonagnetatel
   9.17. Heat exchanger
   9.18. Inlet collector
   9.19. Final collector
+ 10. Engine electrosystems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions



9.12. Electromagnetic valve of a stop of the engine

GENERAL INFORMATION

The unique electric knot in system of injection is an electromagnetic valve of a stop of the engine which is located on the top part of the fuel pump of a high pressure. If the electromagnetic valve of a stop of the engine or a chain of its food is faulty, the engine cannot be started, as supply of fuel to fuel nozzles will be blocked.

Arrangement of a feeding wire of the electromagnetic valve of a stop of the engine

Electromagnetic valve of a stop of the engine, sealing ring, spring and plunzher

PERFORMANCE ORDER
1. Remove an inlet collector.
2. Remove a rubber cover from the top part the valve, unscrew a nut and remove feeding wire (see fig. An arrangement of a feeding wire of the electromagnetic valve of a stop of the engine).
3. Unscrew the electromagnetic valve and take from the fuel pump a plunzher and a spring (see fig. Electromagnetic valve of a stop of the engine, sealing ring, spring and plunzher).
4. Installation is made in sequence, return to removal.