Opel Vectra A

since 1988-1995 of release

Repair and car operation



Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
- 9. Fuel systems of the diesel engine
   9.2. General information
   9.3. Case of the air filter
   9.4. Accelerator pedal
   9.5. Fuel level sensor
   9.6. Fuel tank
   9.7. Heater of the fuel filter
   9.8. Water plums from the fuel filter
   9.9. Filling and pumping of fuel system
   9.10. Check and adjustment of the maximum turns
   9.11. Check and adjustment of turns of idling
   9.12. Electromagnetic valve of a stop of the engine
   9.13. Fuel pump of a high pressure
   9.14. Check and adjustment of the moment of injection of fuel
   9.15. Fuel nozzles
   9.16. Turbonagnetatel
   9.17. Heat exchanger
   9.18. Inlet collector
   9.19. Final collector
+ 10. Engine electrosystems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions



9.18. Inlet collector

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. Weaken the collars, fixing the inlet air channel to a casing of the air filter and remove it from the engine.
3. Weaken collars and unscrew the bolts, fixing the inlet air channel of a turbonagnetatel and remove it from a head of the block of cylinders.
4. Unscrew the bolts, fixing a pipe of an air inlet of the heat exchanger to a collector of a head of the block of cylinders and отсоеди threads a pipe from a collector. Weaken a collar of fastening of other party of a pipe and remove a pipe from the engine.
5. Weaken a collar and remove a vacuum hose of the fuel pump from a back part of a collector.
6. Unscrew screws and remove an arm of a plait of wires from a collector.
7. Evenly and gradually unscrew bolts and the nuts, fixing an inlet collector to a head of the block of cylinders.
8. Remove an inlet collector together with laying.
9. Check that interfaced surfaces of an inlet collector and a head of the block of cylinders, pure and dry and establish new laying on collector racks.
10. Establish a collector and, working in diagonal sequence, evenly and gradually tighten nuts and bolts of fastening of a collector the demanded moment.
11. Establish an arm of a plait of wires.
12. Connect a vacuum hose of the fuel pump to a collector.
13. Establish a pipe of an air inlet of the heat exchanger, using new laying. Tighten bolts of fastening of a pipe and connect an inlet hose.
14. Establish inlet channels and connect the accumulator.
15. Start the engine and check tightness of fuel system.