Opel Vectra A

since 1988-1995 of release

Repair and car operation



Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
- 9. Fuel systems of the diesel engine
   9.2. General information
   9.3. Case of the air filter
   9.4. Accelerator pedal
   9.5. Fuel level sensor
   9.6. Fuel tank
   9.7. Heater of the fuel filter
   9.8. Water plums from the fuel filter
   9.9. Filling and pumping of fuel system
   9.10. Check and adjustment of the maximum turns
   9.11. Check and adjustment of turns of idling
   9.12. Electromagnetic valve of a stop of the engine
   9.13. Fuel pump of a high pressure
   9.14. Check and adjustment of the moment of injection of fuel
   9.15. Fuel nozzles
   9.16. Turbonagnetatel
   9.17. Heat exchanger
   9.18. Inlet collector
   9.19. Final collector
+ 10. Engine electrosystems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions



9.2. General information

GENERAL INFORMATION

The fuel system consists of the car of a fuel tank established under a back part, the fuel filter with a separator of water, the fuel pump of a high pressure, fuel nozzles and pipelines. Before receipt in the filter fuel heats up электричес Kim a heater which is attached to the filter case.

Supply of fuel from the fuel filter to the fuel pump of a high pressure is provided with the pumping-up lopastny pump located in the fuel pump of a high pressure. Excess of fuel greases the fuel pump of a high pressure and comes back to a fuel tank.

The drive of the fuel pump is carried out by a gear belt. Speed of rotation of the fuel pump twice is less than speed of rotation of a cranked shaft.

The amount of fuel copes a centrifugal regulator which reacts to the provision of a pedal of management by supply of fuel and frequency of rotation of a cranked shaft. The regulator is connected with the valve of measurement which increases or reduces amount of the fuel delivered for one course of the pump.

The moment of injection of fuel changes automatically, depending on engine turns, the mechanism which turns a plate of a cam or a ring.

Fuel nozzles spray fuel in the vortical chambers located in a head of the block of cylinders. Fuel nozzles should open and be closed at strictly certain pressure. The needle of a fuel nozzle is greased with fuel which collects about a spring and goes on a returnable hose to the fuel pump.

For start of the cold engine glow plugs which heat up vortical chambers are used. The thermostatic capsule on the fuel pump increases turns of idling of the cold engine.

The electromagnetic valve of a stop of the engine blocks supply of fuel to a rotor of the fuel pump at ignition switching off.

Turbonagnetatel is established to increase engine capacity. Thus it lifts pressure of air in an inlet collector above the atmospheric.

Service of the fuel pump and nozzles are very difficult. Therefore it is necessary for making at service station. For long and continuous work of the fuel pump and nozzles it is necessary to exclude hit in fuel system of dirt and water.

Precautions

Turbonagnetatel works at extremely high speeds and temperatures. Do not use a turbonagnetatel at removed any part or a hose. The extraneous particles getting on rotating blades can damage a turbonagnetatel.

Do not increase engine turns at once after start, especially on the cold engine. It is necessary to wait at least some seconds for ensuring normal circulation of oil.

Give the chance to the engine to work in an idling mode within several minutes before switching off after operation of the engine on high turns.

For greasing of the engine use only oil of the recommended quality.