Opel Vectra A

since 1988-1995 of release

Repair and car operation



Vektr A. Opel
+ 1. Maintenance instruction
+ 1.1 Maintenance
+ 2. Engine
+ 3. Repair of DOHC engines
+ 4. Repair of the diesel engine
+ 5. Cooling system
+ 6. Fuel system
+ 7. A fuel and exhaust system of models with system of injection of fuel
+ 8. Exhaust system and system of fall of toxicity of exhaust gases
- 9. Fuel systems of the diesel engine
   9.2. General information
   9.3. Case of the air filter
   9.4. Accelerator pedal
   9.5. Fuel level sensor
   9.6. Fuel tank
   9.7. Heater of the fuel filter
   9.8. Water plums from the fuel filter
   9.9. Filling and pumping of fuel system
   9.10. Check and adjustment of the maximum turns
   9.11. Check and adjustment of turns of idling
   9.12. Electromagnetic valve of a stop of the engine
   9.13. Fuel pump of a high pressure
   9.14. Check and adjustment of the moment of injection of fuel
   9.15. Fuel nozzles
   9.16. Turbonagnetatel
   9.17. Heat exchanger
   9.18. Inlet collector
   9.19. Final collector
+ 10. Engine electrosystems
+ 11. Transmission
+ 12. Mechanical transmission
+ 13. Automatic transmission
+ 14. Power shafts
+ 15. Brake system
+ 16. Suspension bracket
+ 17. Body
+ 18. Electric equipment
+ 19. Check of malfunctions



9.7. Heater of the fuel filter

GENERAL INFORMATION

Prevention

As the heater of the fuel filter consumes a considerable current, at engine start at low temperatures it is recommended to switch off everything consumers of the electric power.


Greasing of a sealing ring of a heater by pure fuel

At temperature reduction viscosity of diesel fuel increases, at the expense of hardening of paraffin containing in fuel. Therefore additives which reduce viscosity of diesel fuel are entered into fuel and allow to make engine start at low temperatures. On Vectra cars the electric heater of the fuel filter which, warming up fuel is established, excludes hardening of particles of paraffin in fuel.

The heater of the fuel filter is located between the fuel filter and the holder of the filter. The sensor constantly takes temperature of fuel passing through the filter.

Disconnect from a heater the electric socket, remove the fuel filter and a heater of the fuel filter.

Installation is made in sequence, return to removal. Before installation grease a sealing ring of a heater with pure fuel (see drawing).